Farber Classroom AV Instructions

To use the projector with the computer:

1. Turn on the computer, if necessary. It may be necessary to pull down the screen.

2. On the white controller box on the wall beside the cabinet, press the ON button once, to turn on the projector (The projector takes a minute or two to warm up).

3. If you cannot see the monitor's image on the screen, keep pressing the "INPT" button until you can (This cycles through the various inputs for the projector).

To turn off the projector:

1. On the white wall controller, press the OFF button once to turn off the projector.

2. Log off the computer.

3. If necessary, put up the screen.

To use the sound system with the computer:

1. Turn on the computer, if necessary, and log on according to the directions.

2. Unlock the black wall cabinet with the combination. (The lock is stiff; it helps to press it closed before pulling it open.)

3. Inside the black wall cabinet, there is an audio receiver. Press the power button on the receiver, and make sure both the right and the left volume controls are set to about ten o'clock.

4. In the center of the black wall cabinet, there is an audio switcher. The "MAC" button should be pressed. If it is not, press it.

5. Adjust volume as necessary with the right and left volume controls.

To turn off the sound system:

1. Power off the audio receiver (if used).

2. Lock the cabinet.

3. Log off the computer.

To play a tape in the VCR:

1. If necessary, pull down the screen.

2. Unlock the black wall cabinet with the combination. (The lock is stiff; it helps to press it closed before pulling it open.)

On the white controller box on the wall beside the cabinet, press the ON button once, to turn on the projector.

The projector takes a minute or two to warm up.

If you cannot see the VCR on the screen, repeatedly press the "INPT" button on the white controller box until you can.

This cycles through the various inputs for the projector.

Inside the black wall cabinet, in the center, there is an audio switcher.

Press the VCR button.

Inside the black wall cabinet, above the audio switcher, there is an audio receiver.

Press the power button on the receiver, and make sure both the right and the left volume controls are set to about ten o'clock.

Press the power button on the VCR.

Select tape type on the VCR (NTSC, PAL, etc.)

Insert the tape into the VCR and press Play.

Adjust volume as necessary with the right and left volume controls.

To turn off the VCR:

Eject the tape.

Power off the VCR.

Power off the audio receiver.

Lock the cabinet.

On the white wall controller, press the OFF button once to turn off the projector.

This page was last modified on: Mar 23, 2007